Bearing Removal And Installation - Honda 2004 Odyssey Service Manual

Bearing Removal and Installation

Special Tools Required
• Driver 07749-0010000
• Seal driver attachment
07GAD-PG40101 or 07GAD-PG40100
• Attachment, 62 x 68 mm 07746-0010500
• Attachment, 72 x 75 mm 07746-0010600
NOTE: Coat all parts with ATF before assembly.
1. To remove the mainshaft bearing (A), countershaft
bearing (B), and secondary shaft bearing (C) from
the transmission housing, expand each snap ring
with the snap ring pliers, then push the bearing out.
NOTE: Do not remove the snap rings unless it's
necessary to clean the grooves in the housing.
B
2. Install the bearings in the direction shown.
3. Expand each snap ring with the snap ring pliers,
and insert the bearing part-way into the housing.
4. Release the pliers, then push the bearing down into
C
A
5. After installing the bearings verify the following:
the housing until the snap ring snaps in place
around it.
• The snap rings (A) are seated in the bearing and
housing grooves.
• The ring end gaps (B) are correct.
B : 0 7 mm
C
A
B
(0 0.28 in.)
A
14-193