Final Driven Gear Replacement; Tapered Roller Bearing Replacement - Honda CR-V 1997 Service Manual

Final Driven Gear Replacement
,. Remove the bolts in a crisscross pattern in several
steps, and remove the final driven gear from the dif-
ferential carrier.
NOTE: The final driven gear bolts have left-hand
threads.
10xl.0mm
103 N·m 110.5 kg/·m, 75.9 Ibf.ftl
left-hand threads
--------- DIFFERENTIAL
CARRIER
FINAL DRIVEN GEAR
Inspect for wear and damage.
TRANSFER DRIVEN GEAR
Inspect for wear and damage.
2. Install the final driven gear by tightening the bolts
in a crisscross pattern in several steps.
Tapered Roller Bearing
Replacement
Note these items:
• The tapered roller bearing and bearing outer race
should be replaced as a set.
• Inspect and adjust the tapered roller bearing preload
whenever the tapered roller bearing is replaced.
• Check the tapered roller bearings for wear and rough
rotation. If the tapered roller bearings are OK, remov-
al is not necessary.
1. Remove the tapered roller bearings using a bearing
puller and a bearing separator as shown.
2.
BEARING
PULLER
BEARING
SEPARATOR
(Commercially
;0 . . '
TAPERED
ROUER
BEARING
Install new tapered roller bearings using the special
tool as shown.
NOTE: Drive the tapered roller bearings on until
they bottom against the differential carrier.
PRESS
ATTACHMENT,
4OxSOmm
07lAD - PWS0601
ROLLER
BEARING
13-39