Freescale Semiconductor MCF54455 Reference Manual page 246

Field
19 B session valid interrupt status. Indicates when VBUS rises above or falls below the B session valid threshold (0.8
BSVIS VDC). Software must write a 1 to clear this bit.
18 A session valid interrupt status. Indicates when VBUS rises above or falls below the A session valid threshold (0.8
ASVIS VDC). Software must write a 1 to clear this bit.
17 A VBUS valid interrupt status. Indicates when VBUS rises above or falls below the VBUS valid threshold (4.4
AVVIS VDC) on an A device. Software must write a 1 to clear this bit.
16 USB ID interrupt status. Indicates when a change on the ID input is detected. Software must write a 1 to clear this
IDIS bit.
15 Reserved, must be cleared.
14 Data bus pulsing status.
DPS 0 No pulsing on port.
1 Pulsing detected on port.
13 1 millisecond timer toggle. This bit toggles once per millisecond.
1MST
12 B session end.
BSE 0 VBus is above B session end threshold.
1 VBus is below B session end threshold.
11 B Session valid.
BSV 0 VBus is below B session valid threshold.
1 VBus is above B session valid threshold.
10 A Session valid.
ASV 0 VBus is below A session valid threshold.
1 VBus is above A session valid threshold.
9 A VBus valid.
AVV 0 VBus is below A VBus valid threshold.
1 VBus is above A VBus valid threshold.
8 USB ID.
ID 0 A device.
1 B device.
7–6 Reserved, must be cleared.
5 ID Pull-up. Provides control over the ID pull-up resistor.
IDPU 0 Disable pull-up. ID input not sampled.
1 Enable pull-up.
4 Data pulsing.
DP 0 The pull-up on DP is not asserted.
1 The pull-up on DP is asserted for data pulsing during SRP.
3 OTG Termination. This bit must be set with the OTG module in device mode.
OT 0 Disable pull-down on DM.
1 Enable pull-down on DM.
2 Reserved, must be cleared.
Freescale Semiconductor
Table 10-34. OTGSC Field Descriptions (continued)
Universal Serial Bus Interface – On-The-Go Module
Description
10-39