Vrrp-Ipv6-Group - Dell Force10 S4810P Reference Manual

Line Beginning with
Example
FTOS#show vrrp ipv6
------------------
GigabitEthernet 5/6, IPv6 VRID: 255, Version: 3, Net:
fe80::201:e8ff:fe7a:6bb9
VRF: 0 default-vrf
State: Master, Priority: 101, Master: fe80::201:e8ff:fe7a:6bb9
(local)
Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisec
Accept Mode: FALSE, Master AdvInt: 100 centisec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 64
Virtual MAC address:
Virtual IP address:

vrrp-ipv6-group

Assign an interface to a VRRP group.
C-Series, E-Series, S-Series, S4810
Syntax vrrp-ipv6-group vrid
Parameters
vrid
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.4.2.1
Version 8.4.1.0
Version 8.3.7.0
Version 8.3.2.0
1630
Description
•
•
•
00:00:5e:00:02:ff
1::255 fe80::255
Enter the virtual-router ID number of the VRRP group.
•
•
The range of valid VRID values on the E-Series when VRF microcode
is loaded in CAM changed to 1 to 15.
Introduced on the E-Series ExaScale, C-Series, and S-Series.
Introduced on the S4810.
Introduced on the E-Series TeraScale.
UP or DOWN state of the tracked interface or object (Up or
Dn).
Interface type and slot/port or object number, description,
and time since the last change in the state of the tracked
object.
Cost to be subtracted from the VRRP group priority if the
state of the tracked interface/object goes DOWN.
VRID range (C-Series and S-Series): 1 to 255.
VRID range (E-Series): 1 to 255 when VRF microcode is not
loaded and 1 to 15 when VRF microcode is loaded.