Table of Contents
Advertisement
show running-config
show running-config
Description
Displays the current controller configuration, including all pending changes which are yet to be saved.
Syntax
No parameters.
Example
The output of this command shows the running configuration on the controller.
(host) # show running-config
version 5.0
enable secret "******"
telnet soe
loginsession timeout 0
hostname "vjoshi-2400"
clock timezone PST -8
location "Building1.floor1"
mms config 0
controller config 986
ip access-list eth validuserethacl
permit any
!
netservice svc-netbios-dgm udp 138
netservice svc-snmp-trap udp 162
netservice svc-https tcp 443
netservice svc-dhcp udp 67 68 alg dhcp
netservice svc-smb-tcp tcp 445
netservice svc-ike udp 500
netservice svc-l2tp udp 1701
...
...
...
netservice svc-bootp udp 67 69
netservice svc-snmp udp 161
netservice svc-v6-dhcp udp 546 547
netservice svc-icmp 1
--More-- (q) quit (u) pageup (/) search (n) repeat
Command History
This command was available in ArubaOS 3.0
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Licensing
Base operating system
Command Mode
Config or Enable mode on master or local
controllers
show running-config | 1259
Advertisement
Table of Contents
