Cfd Remote-Mep - 3Com S7906E Command Reference Manual

Table 1-4 Rules for generating MIPs
MIP exists on low
level MA
Yes
No
Each of the following actions or cases can cause MIPs to be created or deleted after you have
configured this command:
Enabling CFD (use the cfd enable command)
Creating or deleting the MEPs on a port
Changes occur to the VLAN attribute of a port
The rule specified in the cfd mip-rule command changes
Examples
# Configure the rules for generating MIPs.
<Sysname> system-view
[Sysname] cfd mip-rule default service-instance 5

cfd remote-mep

Syntax
cfd remote-mep remote-mep-id service-instance instance-id mep mep-id
undo cfd remote-mep remote-mep-id service-instance instance-id mep mep-id
View
Ethernet interface view
Default level
2: System level
Parameters
remote-mep-id: ID of the remote MEP, ranging from 1 to 8191.
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
mep mep-id: Specifies the ID of a MEP, ranging from 1 to 8191.
Description
Use the cfd remote-mep command to configure the remote MEP for the specified local MEP (the two
must be in the same service instance) on the local port. After this, the local MEP can receive CCMs from
the remote MEP.
Use the undo cfd remote-mep command to delete the remote MEP configured on the local port.
Note that the remote MEP ID and local MEP ID cannot be the same.
The cfd mip-rule command
is configured as
—
Explicit
Default
1-10
MEP exists on low
level MA
—
No
Yes
—
Create MIP or
not
No
No
Yes
Yes