3Com S7906E Command Reference Manual page 304

View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
Description
Use the display cfd mp command to display the MP information.
If no port is specified, this command will display the MP information of all ports.
The information displayed is ordered by port name primarily, and within a single port, ordered by VLAN
ID (from small to big), and within a single VLAN, in the order of outward-facing MEPs (from low to high
level), MIPs, and inward-facing MEPs (from high to low level).
Examples
# Display the MP information.
<Sysname> display cfd mp
Interface GigabitEthernet2/0/2
MEP ID: 100
Maintenance domain: mdtest0
Maintenance association: mainmd0
MEP ID: 105
Maintenance domain: mdtest5
Maintenance association: mainmd5
MIP
Maintenance domain: mdtest6
Maintenance association: mainmd6
MEP ID: 104
Maintenance domain: mdtest4
Maintenance association: mainmd4
MEP ID: 102
Maintenance domain: mdtest2
Maintenance association: mainmd2
Interface GigabitEthernet2/0/4
MEP ID: 9
Maintenance domain: mdtest6
Maintenance association: matest6
VLAN 100
Level: 0 Service instance: 100
Level: 5 Service instance: 105
Level: 6 Service instance: 106
Level: 4 Service instance: 104
Level: 2 Service instance: 102
VLAN 1
Level: 6 Service instance: 6
Direction: Outbound
Direction: Outbound
Direction: Inbound
Direction: Inbound
Direction: Outbound
1-19