Enabling And Disabling Igmp Snooping - 3Com SuperStack II Manual

Enabling and You can enable or disable IGMP Snooping for all Switch units in the stack
using the
Disabling IGMP
Snooping
To enable or disable IGMP Snooping:
1 At the Top-level menu, enter:
bridge multicastFiltering igmp
The following prompt is displayed:
Enter new value (disable, enable) [disable]:
2 Enter
Displaying and Changing Bridging/VLANs Information
— Displays the maximum age in seconds at which the stored
maxAge
configuration message information is judged to be too old and is
discarded. This value is determined by the root bridge.
— Displays the Hello time value, used when this
bridgeHelloTime
bridge is the root bridge. This value is the time that elapses between
the configuration messages generated by a bridge that assumes itself
to be the root.
— Displays the time that elapses between the
helloTime
configuration messages generated by a bridge that assumes itself to
be the root.
— Displays the forward delay value used when this
bridgeFwdDelay
bridge is the root bridge. This value sets the amount of time that a
bridge spends in the listening and learning states.
— Displays the time that a bridge spends in the
forwardDelay
"listening" and "learning" states.
— Displays the minimum delay time in seconds between
holdTime
sending topology change Bridge Notification Protocol Data Units
(BPDUs).
— Displays the cost of the best path to the root from the
rootCost
root port of the bridge. For example, one determining factor of cost is
the speed of the network interface, that is, the faster the speed, the
smaller the cost.
— Displays the port with the best path from the bridge to
rootPort
the root bridge. Will display a port number, or No Port.
— Displays the configurable value that is appended as the
priority
most significant portion of a bridge identifier.
command on the Multicast Filtering menu.
IGMP
or
enable disable
.
107