Honda Accord 2008 Manual page 1956

07/11/02 09:42:43 61TA0000_210_0092
To run the sensor input display mode, follow these steps
1. Turn the ignition switch to LOCK (0).
2. Press and hold both the AUTO and RECIRCULATION CONTROL buttons, then start the engine.
3. After the engine starts, release both buttons. The display panel control unit will flash the sensor number and then
the value for that sensor. Record the value displayed.
4. To advance to the next sensor, press the REAR WINDOW DEFOGGER button.
Sensor
1
2
3
4
5
6
7
8
9
A
b
NOTE:
• The sensor values will be displayed in degrees Celsius (°C) or an alphanumeric code. Use the chart to convert
the value to degrees Fahrenheit (°F).
• If the sensor value displays ''Er'' this indicates there is an open or short in the circuit or sensor. Check for DTCs
using the HDS, or refer to checking DTCs by DTC indication.
• If necessary, compare the sensor input display to a known-good vehicle under the same test conditions.
• If the sensor is out of the normal range, refer to the sensor test or substitute a known-good sensor, and recheck.
5. To cancel the sensor input display mode, press the AUTO button or turn the ignition switch to LOCK (0).
Mode Positioning
In-car Temperature
Outside Air Temperature
Solar Radiation Sensor Value: Dark = 00, Flashlight = 04, Cloudy = 10,
Sunny = 65
Evaporator Outlet Air Temperature
Driver's Air Mix Opening (Low value indicates cooler air distribution, higher
value indicates warmer air distribution)
Passenger's Air Mix Opening (Low value indicates cooler air distribution,
higher value indicates warmer air distribution)
Recirculation Control Opening
Vehicle Speed (Vehicle must be driven to display speed)
Engine Coolant Temperature
Vent Temperature Air Out (TAO)
Item Displayed Value
%
°C
°C
2
10 kcal/m ·h
°C
% of opening
% of opening
% of opening
10 km/h
°C
°C
(cont'd)
21-91