Texas Instruments SimpleLink CC2620 Technical Reference Manual page 79

www.ti.com
2.7.2.2 REMAP Register (Offset = 4h) [reset = X]
REMAP is shown in
Remap
This register provides the remap base address location where a matched addresses are remapped. The
three most significant bits and the five least significant bits of the remap base address are hard-coded to
3'b001 and 5'b00000 respectively. The remap base address must be in system space and is it required to
be 8-word aligned, with one word allocated to each of the eight FPB comparators.
31 30 29 28
RESERVED
R-1h
15 14 13 12
Bit Field
31-29 RESERVED
28-5 REMAP
4-0 RESERVED
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 2-25 and described in
Figure 2-25. REMAP Register
27 26 25 24
11 10 9
REMAP
R/W-X
Table 2-49. REMAP Register Field Descriptions
Type Reset
R 1h
R/W X
R 0h
Copyright © 2015, Texas Instruments Incorporated
Table 2-49.
23 22 21
REMAP
R/W-X
8 7 6 5
Description
This field always reads 3'b001. Writing to this field is ignored.
Remap base address field.
This field always reads 0. Writing to this field is ignored.
Cortex-M3 Processor Registers
20 19 18 17
4 3 2 1
RESERVED
R-0h
16
0
79