Download Print this page

Texas Instruments SimpleLink CC2620 Technical Reference Manual page 213

Zigbee rf4ce wireless mcu simplelink cc13 series; simplelink cc26 series

Advertisement

www.ti.com
2.7.5.6
FFCR Register (Offset = 304h) [reset = 102h]
FFCR is shown in
Formatter and Flush Control
When one of the two single wire output (SWO) modes is selected, ENFCONT enables the formatter to be
bypassed. If the formatter is bypassed, only the ITM/DWT trace source (ATDATA2) passes through. The
TPIU accepts and discards data that is presented on the ETM port (ATDATA1). This function is intended
to be used when it is necessary to connect a device containing an ETM to a trace capture device that is
only able to capture Serial Wire Output (SWO) data. Enabling or disabling the formatter causes
momentary data corruption.
Note: If the selected pin protocol register (SPPR.PROTOCOL) is set to 0x00 (TracePort mode), this
register always reads 0x102, because the formatter is automatically enabled. If one of the serial wire
modes is then selected, the register reverts to its previously programmed value.
31
30
23
22
15
14
7
6
Bit
Field
31-9
RESERVED
8
TRIGIN
7-2
RESERVED
1
ENFCONT
0
RESERVED
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 2-136
and described in
Figure 2-136. FFCR Register
29
28
21
20
13
12
RESERVED
R/W-0h
5
4
RESERVED
R/W-0h
Table 2-163. FFCR Register Field Descriptions
Type
Reset
R/W
0h
R/W
1h
R/W
0h
R/W
1h
R/W
0h
Copyright © 2015, Texas Instruments Incorporated
Table
2-163.
27
RESERVED
R/W-0h
19
RESERVED
R/W-0h
11
3
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Indicates that triggers are inserted when a trigger pin is asserted.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Enable continuous formatting:
0: Continuous formatting disabled
1: Continuous formatting enabled
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Cortex-M3 Processor Registers
26
25
18
17
10
9
2
1
ENFCONT
RESERVED
R/W-1h
24
16
8
TRIGIN
R/W-1h
0
R/W-0h
213

Hide quick links:

Advertisement

loading