Texas Instruments SimpleLink CC2620 Technical Reference Manual page 357

www.ti.com
4.7.2.72 UDMACH11BSEL Register (Offset = 55Ch) [reset = 4Fh]
UDMACH11BSEL is shown in
Output Selection for DMA Channel 11 REQ
DMA_DONE for the corresponding DMA channel is available as interrupt on GPT1 as
GPT1:RIS.DMAARIS.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
Bit Field
31-7 RESERVED
6-0 EV
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 4-81 and described in
Figure 4-81. UDMACH11BSEL Register
RESERVED
R-0h
Table 4-86. UDMACH11BSEL Register Field Descriptions
Type Reset
R 0h
R/W 4Fh
Copyright © 2015, Texas Instruments Incorporated
Table 4-86.
9
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Read/write selection value
0h = Always inactive
4Dh = GPT0A DMA trigger event. Configured by GPT0:DMAEV
4Eh = GPT0B DMA trigger event. Configured by GPT0:DMAEV
4Fh = GPT1A DMA trigger event. Configured by GPT1:DMAEV
50h = GPT1B DMA trigger event. Configured by GPT1:DMAEV
51h = GPT2A DMA trigger event. Configured by GPT2:DMAEV
52h = GPT2B DMA trigger event. Configured by GPT2:DMAEV
53h = GPT3A DMA trigger event. Configured by GPT3:DMAEV
54h = GPT3B DMA trigger event. Configured by GPT3:DMAEV
79h = Always asserted
Interrupts and Events Registers
8 7 6 5 4 3 2 1
EV
R/W-4Fh
Interrupts and Events
0
357