Texas Instruments SimpleLink CC2620 Technical Reference Manual page 759

www.ti.com
9.2.1.40 FLASH_OTP_DATA3 Register (Offset = 2B0h) [reset = X]
FLASH_OTP_DATA3 is shown in
Flash OTP Data 3
31 30
23 22
EC_STEP_SIZ DO_PRECOND
E
R-0h R-0h
15 14
7 6
Bit Field
31-23 EC_STEP_SIZE
22 DO_PRECOND
21-18 MAX_EC_LEVEL
17-16 TRIM_1P7
15-8 FLASH_SIZE
7-0 WAIT_SYSCODE
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 9-62
Figure 9-62. FLASH_OTP_DATA3 Register
29 28
EC_STEP_SIZE
21 20
MAX_EC_LEVEL
13 12
FLASH_SIZE
5 4
WAIT_SYSCODE
Table 9-64. FLASH_OTP_DATA3 Register Field Descriptions
Type Reset
R 0h
R 0h
R 4h
R 1h
R X
R 3h
Copyright © 2015, Texas Instruments Incorporated
and described in Table 9-64.
27 26
R-0h
19 18
R-4h
11 10
R-X
3 2
R-3h
Description
Value will be written to FLASH:FSM_STEP_SIZE.EC_STEP_SIZE
by the flash device driver when a erase/program operation is
initiated.
Value will be written to FLASH:FSM_ST_MACHINE.DO_PRECOND
by the flash device driver when a erase/program operation is
initiated.
Note that during a Total Erase operation the flash bank will always
be erased with Precondition enabled independent of the value of this
FCFG1 bit field.
Value will be written to FLASH:FSM_ERA_PUL.MAX_EC_LEVEL by
the flash device driver when a erase/program operation is initiated.
Value will be written to FLASH:FSEQPMP.TRIM_1P7 by the flash
device driver when a erase/program operation is initiated.
Value will be written to FLASH:FLASH_SIZE.SECTORS by the boot
FW while in safe zone.
This register will be write protected by the boot FW by setting
FLASH:CFG.CONFIGURED.
Default value differs depending on partnumber.
Value will be written to FLASH:WAIT_SYSCODE.WAIT_SYSCODE
by boot FW code while in safezone.
Factory Configuration (FCFG)
25 24
17 16
TRIM_1P7
R-1h
9 8
1 0
759
Device Configuration