Texas Instruments SimpleLink CC2620 Technical Reference Manual page 59

www.ti.com
2.7.1.7 FOLDCNT Register (Offset = 18h) [reset = X]
FOLDCNT is shown in
Fold Count
This register is used to count the total number of folded instructions. The counter increments on each
instruction which takes 0 cycles.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
Bit Field
31-8 RESERVED
7-0 FOLDCNT
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 2-10 and described in
Figure 2-10. FOLDCNT Register
RESERVED
R/W-0h
Table 2-33. FOLDCNT Register Field Descriptions
Type Reset
R/W 0h
R/W X
Copyright © 2015, Texas Instruments Incorporated
Table 2-33.
9
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
This counts the total number folded instructions. This counter
initializes to 0 when it is enabled using CTRL.FOLDEVTENA.
Cortex-M3 Processor Registers
8 7 6 5 4 3 2 1
FOLDCNT
R/W-X
0
59