Texas Instruments SimpleLink CC2620 Technical Reference Manual page 695

www.ti.com
9.1.1.5 VOLT_LOAD_0 Register (Offset = FB8h) [reset = FFFFFFFFh]
VOLT_LOAD_0 is shown in
Voltage Load 0
Enabled by MODE_CONF.VDDR_EXT_LOAD.
31 30 29 28
VDDR_EXT_TP45
R/W-FFh
15 14 13 12
VDDR_EXT_TP5
R/W-FFh
Bit Field
31-24 VDDR_EXT_TP45
23-16 VDDR_EXT_TP25
15-8 VDDR_EXT_TP5
7-0 VDDR_EXT_TM15
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 9-5 and described in
Figure 9-5. VOLT_LOAD_0 Register
27 26 25 24
11 10 9 8
Table 9-6. VOLT_LOAD_0 Register Field Descriptions
Type Reset
R/W FFh
R/W FFh
R/W FFh
R/W FFh
Copyright © 2015, Texas Instruments Incorporated
Table 9-6.
23 22 21 20
VDDR_EXT_TP25
R/W-FFh
7 6 5 4
VDDR_EXT_TM15
R/W-FFh
Description
Reserved for future use. Software must not rely on the value of a
reserved. Writing any other value than the reset/default value may
result in undefined behavior.
Reserved for future use. Software must not rely on the value of a
reserved. Writing any other value than the reset/default value may
result in undefined behavior.
Reserved for future use. Software must not rely on the value of a
reserved. Writing any other value than the reset/default value may
result in undefined behavior.
Reserved for future use. Software must not rely on the value of a
reserved. Writing any other value than the reset/default value may
result in undefined behavior.
Customer Configuration (CCFG)
19 18 17 16
3 2 1
Device Configuration
0
695