Texas Instruments SimpleLink CC2620 Technical Reference Manual page 384

Interrupts and Events Registers
4.7.2.92 AUXSEL0 Register (Offset = 700h) [reset = 10h]
AUXSEL0 is shown in
Output Selection for AUX Subscriber 0
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
Bit Field
31-7 RESERVED
6-0 EV
384
Interrupts and Events
Figure 4-101 and described in
Figure 4-101. AUXSEL0 Register
RESERVED
R-0h
Table 4-106. AUXSEL0 Register Field Descriptions
Type Reset
R 0h
R/W 10h
Copyright © 2015, Texas Instruments Incorporated
Table 4-106.
9
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Read/write selection value
0h = Always inactive
Ch = GPT2A interrupt event, controlled by GPT2:TAMR
Dh = GPT2B interrupt event, controlled by GPT2:TBMR
Eh = GPT3A interrupt event, controlled by GPT3:TAMR
Fh = GPT3B interrupt event, controlled by GPT3:TBMR
10h = GPT0A interrupt event, controlled by GPT0:TAMR
11h = GPT0B interrupt event, controlled by GPT0:TBMR
12h = GPT1A interrupt event, controlled by GPT1:TAMR
13h = GPT1B interrupt event, controlled by GPT1:TBMR
79h = Always asserted
SWCU117C – February 2015 – Revised September 2015
www.ti.com
8 7 6 5 4 3 2 1
EV
R/W-10h
Submit Documentation Feedback
0