Texas Instruments SimpleLink CC2620 Technical Reference Manual page 756

Factory Configuration (FCFG)
9.2.1.37 FLASH_VHV_PV Register (Offset = 194h) [reset = X]
FLASH_VHV_PV is shown in
Flash VHV Program Verify
31 30 29 28
RESERVED
R-0h
15 14 13 12
VCG2P5
Bit Field
31-28 RESERVED
27-24 TRIM13_PV
23-20 RESERVED
19-16 VHV_PV
15-8 VCG2P5
7-0 VINH
756
Device Configuration
Figure 9-59 and described in
Figure 9-59. FLASH_VHV_PV Register
27 26 25
TRIM13_PV
R-X
11 10 9
R-X
Table 9-61. FLASH_VHV_PV Register Field Descriptions
Type Reset
R 0h
R X
R 0h
R 8h
R X
R 1h
Copyright © 2015, Texas Instruments Incorporated
Table 9-61.
24 23 22 21
RESERVED
R-0h
8 7 6 5
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT1.TRIM13_PV by the flash
device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT1.VHVCT_PV by the flash
device driver when an erase/program operation is initiated.
Control gate voltage during read, read margin, and erase verify.
Value will be written to FLASH:FVNVCT.VCG2P5CT by the flash
device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Inhibit voltage applied to unselected columns during programming.
SWCU117C – February 2015 – Revised September 2015
www.ti.com
20 19 18 17
VHV_PV
R-8h
4 3 2 1
VINH
R-1h
Submit Documentation Feedback
16
0