Texas Instruments SimpleLink CC2620 Technical Reference Manual page 436

PRCM Registers
6.2.1.4 AMPCOMPCTL Register (Offset = Ch) [reset = 0h]
AMPCOMPCTL is shown in
Amplitude Compensation Control
31 30
SPARE31 AMPCOMP_RE
Q_MODE
R/W-0h R/W-0h
23 22
IBIAS_OFFSET
15 14
7 6
CAP_STEP
Bit Field
31 SPARE31
30 AMPCOMP_REQ_MODE
29-28 AMPCOMP_FSM_UPDAT R/W
E_RATE
27 AMPCOMP_SW_CTRL
26 AMPCOMP_SW_EN
25-24 RESERVED
23-20 IBIAS_OFFSET
19-16 IBIAS_INIT
15-8 LPM_IBIAS_WAIT_CNT_
FINAL
7-4 CAP_STEP
3-0 IBIASCAP_HPTOLP_OL_ R/W
CNT
436
Power, Reset, and Clock Management
Figure 6-10 and described in
Figure 6-10. AMPCOMPCTL Register
29 28
AMPCOMP_FSM_UPDATE_RA
TE
R/W-0h
21 20
R/W-0h
13 12
LPM_IBIAS_WAIT_CNT_FINAL
5 4
R/W-0h
Table 6-12. AMPCOMPCTL Register Field Descriptions
Type Reset
R/W 0h
R/W 0h
0h
R/W 0h
R/W 0h
R/W 0h
R/W 0h
R/W 0h
R/W 0h
R/W 0h
0h
Copyright © 2015, Texas Instruments Incorporated
Table 6-12.
27 26
AMPCOMP_S AMPCOMP_S
W_CTRL W_EN
R/W-0h R/W-0h
19 18
11 10
R/W-0h
3 2
IBIASCAP_HPTOLP_OL_CNT
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
Internal. Only to be used through TI provided API.
SWCU117C – February 2015 – Revised September 2015
www.ti.com
25 24
RESERVED
R/W-0h
17 16
IBIAS_INIT
R/W-0h
9
1
R/W-0h
Submit Documentation Feedback
8
0