Texas Instruments SimpleLink CC2620 Technical Reference Manual page 757

www.ti.com
9.2.1.38 FLASH_V Register (Offset = 198h) [reset = X]
FLASH_V is shown in
Flash Voltages
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
VSL_P
R-X
Bit Field
31-24 VSL_P
23-16 VWL_P
15-8 V_READ
7-0 RESERVED
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 9-60 and described in
Figure 9-60. FLASH_V Register
VWL_P
R-X
Table 9-62. FLASH_V Register Field Descriptions
Type Reset
R X
R X
R X
R X
Copyright © 2015, Texas Instruments Incorporated
Table 9-62.
9
V_READ
R-X
Description
Sourceline voltage applied to the selected block during
programming. Value will be written to FLASH:FVSLP.VSL_P by the
flash device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Wordline voltage applied to the selected half-row during
programming. Value will be written to FLASH:FVWLCT.VWLCT_P
by the flash device driver when an erase/program operation is
initiated.
Default value holds trim value from production test.
Wordline voltage applied to the selected block during reads and
verifies. Value will be written to FLASH:FVREADCT.VREADCT by
the flash device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Default value holds trim value from production test.
Factory Configuration (FCFG)
8 7 6 5 4 3 2 1
RESERVED
R-X
Device Configuration
0
757