Texas Instruments SimpleLink CC2620 Technical Reference Manual page 133

www.ti.com
2.7.4.4 STRVR Register (Offset = 14h) [reset = X]
STRVR is shown in
SysTick Reload Value
This register is used to specify the start value to load into the current value register STCVR.CURRENT
when the counter reaches 0. It can be any value between 1 and 0x00FFFFFF. A start value of 0 is
possible, but has no effect because the SysTick interrupt and STCSR.COUNTFLAG are activated when
counting from 1 to 0.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
RESERVED
R/W-0h
Bit Field
31-24 RESERVED
23-0 RELOAD
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 2-74 and described in
Figure 2-74. STRVR Register
Table 2-100. STRVR Register Field Descriptions
Type Reset
R/W 0h
R/W X
Copyright © 2015, Texas Instruments Incorporated
Table 2-100.
9
RELOAD
R/W-X
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value to load into the SysTick Current Value Register
STCVR.CURRENT when the counter reaches 0.
Cortex-M3 Processor Registers
8 7 6 5 4 3 2 1 0
133