Texas Instruments SimpleLink CC2620 Technical Reference Manual page 866

Cryptography Registers
10.2.1.35 IRQTYPE Register (Offset = 780h) [reset = 0h]
IRQTYPE is shown in
Interrupt Configuration
31 30 29 28
15 14 13 12
Bit Field
31-1 RESERVED
0 IEN
866
Figure 10-37 and described in
Figure 10-37. IRQTYPE Register
27 26 25 24
RESERVED
R/W-0h
11 10 9 8
RESERVED
R/W-0h
Table 10-45. IRQTYPE Register Field Descriptions
Type Reset
R/W 0h
R/W 0h
Copyright © 2015, Texas Instruments Incorporated
Table 10-45.
23 22 21 20
7 6 5 4
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Interrupt enable. This bit must be set to 1 to enable interrupts from
the Crypto peripheral.
0 : All interrupts are disabled enabled.
1 : All interrupts are enabled.
SWCU117C – February 2015 – Revised September 2015
www.ti.com
19 18 17 16
3 2 1 0
IEN
R/W-
0h
Submit Documentation Feedback