Texas Instruments CC2650 Quick Start Manual
Hide thumbs
Also See for CC2650:
- Quick start manual (3 pages) ,
- Getting started (2 pages) ,
- Technical reference manual (1627 pages)
Related Manuals for Texas Instruments CC2650
Summary of Contents for Texas Instruments CC2650
- Page 1 CC2650 Packet Error Rate Test Quick Start Guide Version Updated 0.0.2 17. September 2013 Revised for rev 0.1.0 of PER Test TI Confidential – NDA Restrictions Page 1 of 4...
- Page 2 This guide describes how to use the Packet Error Rate (PER) test with CC2650. Prerequisites In order to use the PER test, please set up your SmartRF06EB according to the “CC2650 Alpha Release Quick start guide” as the silicon qual package can become damaged if not.
- Page 3 CC2650 Packet Error Rate Test Quick Start Guide Mode menu In the mode menu, you can select which device is transmitting and which is receiving: BLE Transmitter BLE Receiver After selecting “BLE Receiver”, the device goes directly into receive mode and is ready to receive packets.
-
Page 4: Regulatory Information
LDO on the SmartRF06EB. Known bugs and issues Regulatory Information The CC2650 evaluation module (7IDEM) is FCC and IC certified and tested to comply with ETSI R&TTE regulations over temperature from 0 to +35°C. The evaluation module has an integrated PCB antenna. - Page 5 Any exceptions to this are strictly prohibited and unauthorized by Texas Instruments unless user has obtained appropriate experimental/development licenses from local regulatory authorities, which is responsibility of user including its acceptable authorization.
- Page 6 FCC Interference Statement for Class B EVM devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 7 Also, please do not transfer this product, unless you give the same notice above to the transferee. Please note that if you could not follow the instructions above, you will be subject to penalties of Radio Law of Japan. Texas Instruments Japan Limited (address) 24-1, Nishi-Shinjuku 6 chome, Shinjuku-ku, Tokyo, Japan http://www.tij.co.jp...
- Page 8 FDA Class III or similar classification, then you must specifically notify TI of such intent and enter into a separate Assurance and Indemnity Agreement. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2013, Texas Instruments Incorporated...