Texas Instruments SimpleLink CC2620 Technical Reference Manual page 755

www.ti.com
9.2.1.36 FLASH_VHV Register (Offset = 190h) [reset = X]
FLASH_VHV is shown in
Flash VHV
31 30 29 28
RESERVED
R-0h
15 14 13 12
RESERVED
R-0h
Bit Field
31-28 RESERVED
27-24 TRIM13_P
23-20 RESERVED
19-16 VHV_P
15-12 RESERVED
11-8 TRIM13_E
7-4 RESERVED
3-0 VHV_E
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 9-58 and described in
Figure 9-58. FLASH_VHV Register
27 26 25 24
TRIM13_P
R-X
11 10 9 8
TRIM13_E
R-X
Table 9-60. FLASH_VHV Register Field Descriptions
Type Reset
R 0h
R X
R 0h
R X
R 0h
R X
R 0h
R 4h
Copyright © 2015, Texas Instruments Incorporated
Table 9-60.
23 22 21 20
RESERVED
R-0h
7 6 5 4
RESERVED
R-0h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT2.TRIM13_P by the flash
device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT2.VHVCT_P by the flash
device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT1.TRIM13_E by the flash
device driver when an erase/program operation is initiated.
Default value holds trim value from production test.
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Value will be written to FLASH:FVHVCT1.VHVCT_E by the flash
device driver when an erase/program operation is initiated
Factory Configuration (FCFG)
19 18 17 16
VHV_P
R-X
3 2 1 0
VHV_E
R-4h
755
Device Configuration