Traceroute Address Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
traceroute <address>
Use the traceroute command to display the Internet Protocol (IP) routes a packet takes to reach the
specified destination.
Syntax Description
<address>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example performs a traceroute on the IP address 192.168.0.1:
#traceroute 192.168.0.1
Type CTRL+C to abort.
Tracing route to 192.168.0.1 over a maximum of 30 hops
1 22ms 20ms 20ms
2 23ms 20ms 20ms
#
61200990L1-35E
Specifies the IP address of the remote system to trace the routes to.
Command was introduced.
192.168.0.65
192.168.0.1
Copyright © 2005 ADTRAN
Basic Mode Command Set
25