Show Interface Pfc - Dell MXL 10GbE Reference Manual

TLV
Pkts

show interface pfc

Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
Syntax
show interface port-type slot/port pfc {summary | detail}
Parameters
port-type slot/
port pfc
{summary |
detail}
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
To clear the PFC TLV counters, use the clear pfc counters interface
Information
port-type slot/port command.
The following describes the show interface pfc summary command shown in
the following example.
Field
Interface
Admin mode is on
Admin is enabled
Remote is
enabled, Priority
list Remote
Willing Status is
enabled
Local is enabled
Data Center Bridging (DCB)
Enter the port-type slot and port PFC information.
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Interface type with stack-unit and port number.
PFC admin mode is on or off with a list of the configured
PFC priorities. When the PFC admin mode is on, PFC
advertisements are enabled to be sent and received from
peers; received PFC configuration take effect. The admin
operational status for a DCBX exchange of PFC
configuration is enabled or disabled.
Operational status (enabled or disabled) of peer device for
DCBX exchange of PFC configuration with a list of the
configured PFC priorities. Willing status of peer device for
DCBX exchange (Willing bit received in PFC TLV): enabled or
disable.
DCBX operational status (enabled or disabled) with a list of
the configured PFC priorities.
447