Ip Multicast-Lag-Hashing; Ip Multicast-Limit - Dell Force10 S4810P Reference Manual

Related show ip mroute
Commands

ip multicast-lag-hashing

Distribute multicast traffic among port channel members in a round-robin fashion.
E-Series
Syntax ip multicast-lag-hashing
To revert to the default, use the no ip multicast-lag-hashing command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 6.3.1.0
Usage By default, one port channel member is chosen to forward multicast traffic. With this feature
Information turned on, multicast traffic is distributed among the port channel members in a round-robin
fashion. This feature applies to the routed multicast traffic. If you turn on internet group
management protocol (IGMP) snooping, this feature also applies to switched multicast traffic.
Related

ip multicast-limit

Commands
ip multicast-limit
Use this feature to limit the number of multicast entries on the system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip multicast-limit limit
Parameters
limit
Defaults
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
– views the E-Series routing table.
Introduced on the E-Series.
– enables IP multicast forwarding.
Enter the desired maximum number of multicast entries on the
system. The E-Series range is 50000, the C-Series range is 1 to 10000,
and the S-Series range is 1 to 2000.
• E-Series Default: 15000.
• C-Series Default: 4000.
• S-Series Default: 400.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series.
1119