Show Interface Ets - Dell MXL 10GbE Reference Manual

Local DCBX Compatibility mode is CEE
Local DCBX Status
-----------------
Peer DCBX Status:
----------------

show interface ets

Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
{summary |
detail}
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
To clear ETS TLV counters, use the clear ets counters interface port-
Information
type slot/port command.
The following describes the show interface summary command shown in the
following example.
Data Center Bridging (DCB)
DCBX Operational Status is Enabled
Is Configuration Source? TRUE
Local DCBX Configured mode is CEE
Peer Operating version is CEE
Local DCBX TLVs Transmitted: ErPfi
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
Enter the port-type slot and port ETS information.
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
443