Static Ip Addresses - Dell MXG610s Setup Manual

• In a UNIX environment using TIP, enter tip /dev/ttyb -9600. at the prompt.
• If you are already using ttyb, use ttya instead and enter tip /dev/ttya -9600
at the prompt.
4 Press enter when the terminal emulator application stops reporting information to
display the login prompt.
Switch Console Login:
5 Log in to the switch module as admin, using the default password: password.
You are prompted to change the default admin and user passwords at initial login. Write
down the new passwords, and keep this information in a secure location.
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
swDir:admin>
6 (Optional) Modify passwords.
To skip modifying the password, press Ctrl+C.
NOTE: Passwords are 8 to 40 characters long. They must begin with an
alphabetic character. They can include numeric characters, the period (.), and
the underscore (_) only. Passwords are case-sensitive, and do display when
you enter them on the command line.

Static IP addresses

Dell EMC recommends configuring the switch module through the blade server chassis
management GUI, namely, Dell EMC OpenManage Enterprise Modular. Use this
management GUI to configure the switch IP address and perform advanced configuration
tasks. By default, the IP address mode is set to DHCP. Use this GUI to assign a static IP
address. To configure the FC switch module, follow these steps:
1 Log in to the blade server chassis management GUI application.
Figure 4. OpenManage Enterprise modular
2 Select Devices > I/O modules.
MXG610s Setup Guide 9