Show Qos Priority-Groups - Dell MXL 10GbE Reference Manual

show qos priority-groups

Displays the ETS priority groups configured on the switch, including the 802.1p priority classes and ID of
each group.
Syntax
show qos priority-groups
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
Information
Example
Dell#show qos priority-groups
priority-group ipc
show stack-unit stack-ports ets details
Displays the ETS configuration applied to egress traffic on stacked ports, including ETS Operational mode
on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and
scheduler type.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-
number} ets details
Parameters
stack-unit
port-number
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Example
Dell(conf)# show stack-unit all stack-ports all ets details
Stack unit 0 stack port all
452
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
priority-list 4
set-pgid 2
Enter the stack unit identification.
Enter the port number.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)