Command
EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text
Defaults
none
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Related
•
Commands
•
•
•
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
428
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the description of the output policy. The maximum is
32 characters.
DCB INPUT POLICY
DCB OUTPUT POLICY
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
dcb-input
— creates a DCB PFC input policy.
dcb-policy input
— applies the output policy.
dcb-output
— creates a DCBETS output policy.
dcb-policy output
— applies the output policy.
Data Center Bridging (DCB)