Table of Contents
Advertisement
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
FC Flex IO Modules with MXL
Syntax
show qos dcb-map map-name
Parameters
map-name
Command
•
Modes
•
Command
Version 9.3(0.0)
History
Usage
Use the show qos dcb-map command to display the enhanced transmission
Information
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the
example below.
Field
State
PFC Mode
PG
TSA
BW
PFC
Priorities
Example
Dell# show qos dcb-map dcbmap2
State
PfcMode:ON
--------------------
PG:0 TSA:ETS
Priorities:0 1 2 4 5 6 7
462
Displays the PFC and ETS parameters configured in the
specified map.
EXEC
EXEC Privilege
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Description
Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
PFC configuration in DCB map: On (enabled) or Off.
Priority group configured in the DCB map.
Transmission scheduling algorithm used by the priority
group: Enhanced Transmission Selection (ETS).
Percentage of bandwidth allocated to the priority group.
PFC setting for the priority group: On (enabled) or Off.
802.1p priorities configured in the priority group.
:Complete
BW:50
PFC:OFF
Data Center Bridging (DCB)
Advertisement
Table of Contents
