Ipv6 Pim Rp-Candidate - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

ipv6 pim rp-candidate

ipv6 pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
Syntax
[ hold-time holdTime ] [ priority priority ] [ interval interval ]
no ipv6 pim rp-candidate interfaceType interfaceSpecifier
[ group-list accessListName ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines a router as a rendezvous point (RP) router candidate. The no version stops
Description
the router from being an RP candidate.
Options
Global Configuration
Mode
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see "Interface Types and Specifiers" on page 5. The autoRP announcement
messages will contain the IP address for this interface.
accessListName Access-list containing the set of group prefixes supported by
this C-RP. If no group-list is specified, the default value is the entire multicast
address range.
holdTime Amount of time in the range 1–65535 seconds that the BSR keeps
an RP in its C-RP list if the BSR does not receive a C-RP advertisement message;
default value is 150 seconds
priority Priority field value in the range 0– 255 that the C-RP sends to the BSR
in C-RP advertisement messages; default value is 192. In the RP election process,
the RP with the lower priority value is preferred.
interval Interval in the range 1–65535 seconds at which the C-RP sends
advertisement messages to the BSR; default value is 60 seconds
Chapter 10: I Commands
1079
ipv6 pim rp-candidate