Advertisement
M16C/5L Group, M16C/56 Group
15.5.6
Timer A (Programmable Output Mode)
15.5.6.1
Changing the Operating Mode
The IR bit becomes 1 when setting a timer operating mode with any of the following:
•
Selecting PWM mode or programmable output mode after reset
•
Changing the operating mode from timer mode to PWM mode or programmable output mode
•
Changing the operating mode from event counter mode to PWM mode or programmable output
mode
To use the timer Ai interrupt (IR bit), set the IR bit to 0 by a program after the changes listed above
are made.
15.5.6.2
Stop While Counting
When setting the TAiS bit to 0 (count stopped) during pulse output, the following occur:
When the POFSi bit in the TAPOFS register is 0:
•
Counting stops.
•
When the TAiOUT pin is high, the output level goes low.
•
When the TAiOUT pin is low, the output level remains unchanged.
•
The IR bit remains unchanged.
When the POFSi bit in the TAPOFS register is 1:
•
Counting stops
•
When the TAiOUT pin output is low, the output level goes high.
•
When the TAiOUT pin output is high, the output level remains unchanged.
•
The IR bit remains unchanged.
R01UH0127EJ0110 Rev.1.10
Sep 01, 2011
15. Timer A
Page 278 of 803
Advertisement
