Renesas M16C/50 Series User Manual page 215

M16C/5L Group, M16C/56 Group
12.2.10 NMI Digital Debounce Register (NDDR)
NMI Digital Debounce Register
b7
When using the NMI interrupt to exit from stop mode, set FFh to the NDDR register before entering stop
mode. Write to the NDDR register in the next instruction after setting the PRC2 bit in the PRCR register
to 1 (write enabled). No interrupt or DMA transfer should be generated between these two instructions.
12.2.11 P1_7 Digital Debounce Register (P17DDR)
P1_7 Digital Debounce Register
b7
When using the INT5 interrupt to exit from stop mode, set FFh to the P17DDR register before entering
stop mode.
R01UH0127EJ0110 Rev.1.10
Sep 01, 2011
Symbol
b0
NDDR
With n being the setting value:
• n = 00h to FEh:
A signal with larger pulse width than
• n = FFh:
Digital debounce filter function is disabled and all signals will be
input directly.
Symbol
b0
P17DDR
With n being the setting value:
• n = 00h to FEh:
A signal with larger pulse width than
INT5.
• n = FFh:
Digital debounce filter function is disabled and all signals will be
input directly.
Address
02FEh
Function
(n + 1) x 8
is input to NMI/SD.
f1
Address
02FFh
Function
(n + 1) x 8
is input to INPC1_7/
f1
12. Interrupts
Reset Value
FFh
Setting Range RW
00h to FFh RW
Reset Value
FFh
Setting Range RW
00h to FFh RW
Page 178 of 803