Renesas M16C/50 Series User Manual page 376

M16C/5L Group, M16C/56 Group
Table 17.17 Registers and Settings in Sawtooth Wave Modulation Mode (2/2)
Register
TA1TGH to
TA1TGL
TA2TGH to
TA2TGL
TRGSR
TA3TGH to
TA3TGL
TA4TGH to
TA4TGL
TA0S
TA1S
TA2S
TA3S
TABSR
TA4S
TB0S
TB1S
TB2S
TMOD1 to
TMOD0
MR0
TA1MR,
MR1
TA2MR,
TA4MR
MR2
MR3
TCK1 to TCK0 Select a count source.
TMOD1 to
TMOD0
MR1 to MR0
TB2MR
MR3
TCK1 to TCK0 Select a count source.
PCLKR PCLK0
TCKDIVC0 TCDIV00
TACS0 to
7 to 0
TACS2
TBCS1 TCS3 to TCS0 Select a count source.
TAPOFS POFSi
UDF TAiP
i = 1, 2, 4
Note:
1. This table does not describe a procedure.
R01UH0127EJ0110 Rev.1.10
Sep 01, 2011
Bit
Set to 01b (when using V-phase output control circuit).
Set to 01b (when using W-phase output control circuit).
(Not used for three-phase motor control timer.)
Set to 01b (when using U-phase output control circuit).
Not used for three-phase motor control timer.
Set to 1 when starting counting, and to 0 when stopping counting.
Set to 1 when starting counting, and to 0 when stopping counting.
Not used for three-phase motor control timer.
Set to 1 when starting counting, and to 0 when stopping counting.
Not used for three-phase motor control timer.
Not used for three-phase motor control timer.
Set to 1 when starting counting, and to 0 when stopping counting.
Set to 10b (one-shot timer mode).
Set to 0.
Set to 0.
Set to 1 (select a trigger by setting bits TAiTGH and TAiTGL).
Set to 0.
Set to 00b (timer mode).
Set to 00b.
4 Set to 0.
Set to 0.
Select a count source.
Select the clock prior to timer AB division.
Select a count source.
Set to 0.
Set to 0.
17. Three-Phase Motor Control Timer Function
Function and Setting
(1)
Page 339 of 803