Chapter 2: Getting Started
Configuring In-Band Management
Configuring In-Band Management
You can configure in-band management in order to manage the unit remotely via its radio and/or
Ethernet interfaces.
Each PTP 820C unit includes a pre-defined management service with Service ID 257. The
management service is a multipoint service that connects the two local management ports and the
network element host CPU in a single service. In order to enable in-band management, you must
add at least one service point to the management service, in the direction of the remote site or
sites from which you want to access the unit for management.
For instructions on adding service points, see
Configuring Service
Points.
phn-3963_004v000
Page 2-8