Siemens G130 List Manual page 701

Note: SMI: SINAMICS Sensor Module Integrated
p4700[0...1] Trace control / Trace control
CU_G130_PN, Can be changed: U, T
CU_G150_PN,
Data type: Integer16
CU_G130_DP,
P-Group: Trace and function generator
CU_G150_DP
Not for motor type: -
Min
0
Description: Setting to control the trace function.
Value: 0:
1:
Index: [0] = Trace 0
[1] = Trace 1
p4701 Measuring function control / Meas fct ctrl
CU_G130_PN, Can be changed: U, T
CU_G150_PN,
Data type: Integer16
CU_G130_DP,
P-Group: Trace and function generator
CU_G150_DP
Not for motor type: -
Min
0
Description: Setting to control the measurement function.
Value: 0:
1:
2:
3:
p4703[0...1] Trace options / Trace options
CU_G130_PN, Can be changed: T
CU_G150_PN,
Data type: Unsigned16
CU_G130_DP,
P-Group: Trace and function generator
CU_G150_DP
Not for motor type: -
Min
-
Description: Sets the options for the trace.
Index: [0] = Trace 0
[1] = Trace 1
Bit field: Bit
00
Dependency: Refer to: p4700
Note: For bit 00:
0: The trace starts with p4700 as before.
1: When powering up, the trace starts immediately with the saved parameter settings with the start of the time slices.
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
Stop trace
Start trace
Stop measuring function
Start measuring function
Measuring function check parameterization
Start measuring function without enable signals
Signal name
Automatically start trace with time slices
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
1
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
3
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
1 signal
Yes
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0000 bin
0 signal
No
FP
-
701