Siemens G130 List Manual page 260

2 Parameters
2.2 List of parameters
Notice: If telegram 39x is set via p0922 in SINAMICS Integrated, the inversion of the output has no effect.
Regarding the terminal designation:
The first designation is valid for CU320, the second for CU310.
Note: DI/DO: Bidirectional Digital Input/Output
p0771[0...2] CI: Test sockets signal source / Test skt S_src
CU_G130_PN, Can be changed: U, T
CU_G150_PN,
Data type: Unsigned32 / Integer16
CU_G130_DP,
P-Group: Terminals
CU_G150_DP
Not for motor type: -
Min
-
Description: Sets the signal source for the signal to be output at the test sockets.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Can only be set when p0776 = 99.
Refer to: r0772, r0774, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
r0772[0...2] Test sockets output signal / TestSktsSignalVal
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: FloatingPoint32
CU_G130_DP,
P-Group: Terminals
CU_G150_DP
Not for motor type: -
Min
- [%]
Description: Displays the actual value of the signal to be output.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Refer to: p0771, r0774, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
r0774[0...2] Test sockets output voltage / TestSkts U_output
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: FloatingPoint32
CU_G130_DP,
P-Group: Terminals
CU_G150_DP
Not for motor type: -
Min
- [V]
Description: Displays the actual output voltage for the test sockets.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Refer to: p0771, r0772, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
260
Calculated: -
Dyn. index: -
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
- [%]
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
- [V]
List Manual (LH2), 07/2016, A5E03263479A
Access level: 2
Func. diagram: 8134
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 2
Func. diagram: 8134
Unit selection: -
Expert list: 1
Factory setting
- [%]
Access level: 2
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
- [V]
SINAMICS G130/G150