Siemens G130 List Manual page 1018

2 Parameters
2.2 List of parameters
p9913[0...2] Change drive object number / Change drv_obj_no
CU_G130_PN, Can be changed: C1(4)
CU_G150_PN,
Data type: Unsigned16
CU_G130_DP,
P-Group: All groups
CU_G150_DP
Not for motor type: -
Min
0
Description: Existing drive objects can be assigned new numbers using these parameters.
Index 0:
The values 2 ... 62 are permissible.
Index 1:
The values 2 ... 62 are permissible.
Index 2:
= 0: Ready.
= 1: Reset (only indices 0 ... 2).
= 2: Reset all (indices 0 ... 2 and flagged entries).
= 3: Check and flag for modification.
Index: [0] = Drive object number old
[1] = Drive object number new
[2] = Reset or check and flag for modification
Note: Only for internal Siemens use.
The parameter is not displayed for the STARTER commissioning software.
p9914[0...2] Change component number / Change comp_no
CU_G130_PN, Can be changed: C1
CU_G150_PN,
Data type: Unsigned16
CU_G130_DP,
P-Group: All groups
CU_G150_DP
Not for motor type: -
Min
0
Description: You can change the number of topology components using this parameter.
Index 0:
The values 2 ... 199 are permissible.
Index 1:
The values 2 ... 199 are permissible.
Index 2:
= 0: Ready.
= 1: Reset (only indices 0 ... 2).
= 2: Reset all (indices 0 ... 2 and flagged entries).
= 3: Check and flag for modification.
Index: [0] = Component number old
[1] = Component number new
[2] = Reset or check and flag for modification
Note: Only for internal Siemens use.
The parameter is not displayed for the STARTER commissioning software.
1018
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
62
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
199
List Manual (LH2), 07/2016, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
SINAMICS G130/G150