Siemens G130 List Manual page 880

2 Parameters
2.2 List of parameters
p8921[0...3] PN IP address / PN IP addr
CU_G130_PN, Can be changed: U, T
CU_G150_PN
Data type: Unsigned8
P-Group: -
Not for motor type: -
Min
0
Description: Sets the IP address for the onboard PROFINET interface on the Control Unit.
The actual IP address is displayed in r8931.
Dependency: Refer to: p8925, r8931
Note: The interface configuration (p8920 and following) is activated with p8925.
The parameter is not influenced by setting the factory setting.
p8922[0...3] PN Def Gateway / PN Def Gateway
CU_G130_PN, Can be changed: U, T
CU_G150_PN
Data type: Unsigned8
P-Group: -
Not for motor type: -
Min
0
Description: Sets the default gateway for the onboard PROFINET interface on the Control Unit.
The actual standard gateway is displayed in r8932.
Dependency: Refer to: p8925, r8932
Note: The setting p8922[0...3] = 0 or p8922 = p8921 (own IP address) means that a standard gateway has not been set.
The interface configuration (p8920 and following) is activated with p8925.
The parameter is not influenced by setting the factory setting.
p8923[0...3] PN Subnet Mask / PN Subnet Mask
CU_G130_PN, Can be changed: U, T
CU_G150_PN
Data type: Unsigned8
P-Group: -
Not for motor type: -
Min
0
Description: Sets the subnet mask for the onboard PROFINET interface on the Control Unit.
The actual subnet mask is displayed in r8933.
Dependency: Refer to: p8925, r8933
Note: The interface configuration (p8920 and following) is activated with p8925.
The parameter is not influenced by setting the factory setting.
p8924 PN DHCP Mode / PN DHCP mode
CU_G130_PN, Can be changed: U, T
CU_G150_PN
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Sets the DHCP mode for the onboard PROFINET interface on the Control Unit.
The actual DHCP mode is displayed in r8934.
Value: 0:
2:
3:
880
DHCP off
DHCP on, identification using MAC address
DHCP on, identification via name of station
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
255
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
255
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
255
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
3
List Manual (LH2), 07/2016, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150