Siemens G130 List Manual page 1105

Handling BICO technology
Binectors are binary signals that can be freely interconnected (BO = Binector Output).
Binector:
r0723.15
They represent a bit of a "BO:" display parameter (e.g. bit 15 from r0723).
Connectors are bit fields or numerical values that can be freely interconnected (e.g. "analog signals", like percentage variables, speeds or torques).
Connector:
r0723
Connectors are also "CO:" display parameters (CO = Connector Output).
Parameterization:
At the signal destination, the required binector or connector is selected using appropriate parameters:
"BI:" parameter for binectors (BI = Binector Input)
or
"CI:" parameter for connectors (CI = Connector Input)
Example:
The main setpoint for the speed controller (CI: p1070) should be received from the output of the motorized potentiometer (CO: r1050) and
the "jog" command (BI: p1055) from digital input DI 0 (BO: r0722.0, X122.1 terminal) on the CU320.
Digital input
1
DI 0
X122.1 r0722.0
[2120]
Motorized potentiometer
Raise
Lower
[3020]
Parameterizing steps:
1 p1055[0] = 722.0 Terminal X122.1 acts as "Jog bit 0".
2 p1070[0] = 1050 The output of the motorized potentiometer acts as main setpoint for the speed controller.
1 2
DO: All objects
Explanations on the function diagrams - Handling BICO technology
Control word bit 8
r0898.8
p1055 [C]
722.0
[2501]
2
r1050
3 4
Setpoint channel
Main setpoint
p1070[C]
1050
Jog setpoint 1
[3030]
5 6
fp_1030_51_eng.vsd
10.05.11 V04.08.00
Speed controller
7 8
Function diagram
- 1030 -
SINAMICS