Siemens G130 List Manual page 362

2 Parameters
2.2 List of parameters
p1267 Bypass changeover source configuration / Chngov_src config
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: Unsigned8
P-Group: -
Not for motor type: RESM
Min
-
Description: Sets the cause that should initiate the bypass.
Bit field: Bit
00
01
Note: The parameter only has an effect for a non-synchronized bypass.
p1267.0 = 1:
The bypass is initiated by setting a binary signal. When the command is reset, after the debypass delay time (p1263)
has expired, operation at the power unit is re-selected.
p1267.1 = 1:
When the speed threshold entered in p1265 is reached, the bypass is switched in. The system only switches back
when the speed setpoint again falls below the threshold value.
p1268 BI: Bypass feedback synchronization completed / FS sync compl
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: Unsigned32 / Binary
P-Group: -
Not for motor type: RESM
Min
-
Description: Sets the signal source for the feedback signal "synchronization completed" for the bypass function.
Dependency: Refer to: r3819
p1269[0...1] BI: Bypass switch feedback signal / Bypass FS
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: Unsigned32 / Binary
P-Group: -
Not for motor type: RESM
Min
-
Description: Sets the signal source for the feedback signal of the bypass switch.
Index: [0] = Switch motor/drive
[1] = Switch motor/line supply
Note: In the case of switches without a feedback signal, interconnect the corresponding control bit as the signal source:
BI: p1269[0] = r1261.0
BI: p1269[1] = r1261.1
362
Signal name
Bypass via signal (BI: p1266)
Bypass via reaching the speed threshold
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
List Manual (LH2), 07/2016, A5E03263479A
Access level: 2
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 bin
0 signal
No
No
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
3819.2
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150
FP
-
-