Ipv6 Pim Join-Prune-Interval; Ipv6 Pim Register-Threshold - Dell Networking 2024 Reference Manual

Example
console(config-if-vlan3)#ipv6 pim hello-interval 45

ipv6 pim join-prune-interval

Use the ipv6 pim join-prune-interval command to configure the interface
join/prune interval for the PIM-SM router. Use the no form of this command
to set the join/prune interval to the default.
Syntax
ipv6 pim join-prune-interval
no ipv6 pim join-prune-interval
• interval— The join/prune interval (Range: 0–18000 seconds).
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pim join-prune-interval 90

ipv6 pim register-threshold

Use the ipv6 pim register-threshold command to configure the Register
Threshold rate for the RP router to switch to the shortest path. Use the no
form of this command to set the register threshold rate to the default.
Syntax
ipv6 pim register-threshold
no ipv6 pim register-threshold
• threshold—The threshold rate (Range: 0–2000 Kbps).
interval
threshold
IPv6 Multicast Commands
1173