Ip Igmp Snooping Fast-Leave - Dell Z9500 Command Reference Manual

ip igmp snooping fast-leave

Enable IGMP snooping fast-leave for this VLAN.
Z9500
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave
command.
Defaults Not configured.
Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command.
Usage Queriers normally send some queries when a leave message is received prior to
Information deleting a group from the membership database. There may be situations when
you require a fast deletion of a group. When you enable IGMP fast leave
processing, the switch removes an interface from the multicast group as soon as it
detects an IGMP version 2 leave message on the interface.
826
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet Group Management Protocol (IGMP)