Debug Ip Igmp Snooping - Dell Z9500 Command Reference Manual

Version
9.7(0.0)
Usage IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
Information yield results.

debug ip igmp snooping

Enable debugging of IGMP snooping packets on interfaces and groups.
Z9500
Syntax
debug ip igmp snooping [group address | interface]
•
•
Parameters
snooping
group-address
interface
interface
Defaults Disabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
824
Description
Introduced on S-Series and Z–Series.
To disable debugging of IGMP snooping, use the no debug ip igmp
snooping [group address | interface] command.
To disable all debugging, use the undebug all command.
Enter the keyword snooping to enable debugging of IGMP
snooping.
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Description
Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, and Z9500.
Internet Group Management Protocol (IGMP)