Ip Igmp Ssm-Map - Dell Z9500 Command Reference Manual

Version
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.6.1.0
7.5.1.0

ip igmp ssm-map

To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
Z9500
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them
with (*,G) state, use the ip igmp [vrf vrf-name] ssm-map std-access-
list source-address command.
Parameters
vrf vrf-name
std-access-list
source-address
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
814
Description
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
Specify the standard IP access list that contains the mapping
rules for multicast groups.
Specify the multicast source address to which the groups are
mapped.
Internet Group Management Protocol (IGMP)