Ip Igmp Snooping Mrouter - Dell Z9500 Command Reference Manual

Parameters
milliseconds
Defaults 1000 milliseconds
Command INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage This last-member-query-interval is also the interval between successive Group-
Information Specific Query messages. To change the last-member-query interval, use this
command.

ip igmp snooping mrouter

Statically configure a VLAN member port as a multicast router interface.
Z9500
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping
mrouter interface interface command.
Parameters
interface
interface
828
Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the following keywords and slot/port or number
information:
Internet Group Management Protocol (IGMP)