Ipv6 Pim Register-Filter; Ipv6 Pim Rp-Address - Dell Z9500 Reference Manual

ipv6 pim register-filter

Configure the source DR so that it does not send register packets to the RP for the specified sources and
groups.
Z9500
Syntax
ipv6 pim register-filter access-list
Parameters
access-list
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
8.3.19.0
8.3.12.0
8.3.1.0
Example
Dell(conf)#ipv6 pim register-filter REG-FIL_ACL
Dell(conf)#ipv6 access-list REG-FIL_ACL
Dell(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any any
Dell(conf-ipv6-acl)#exit

ipv6 pim rp-address

Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to
send register packets on behalf of the source multicast host.
Z9500
Syntax
ipv6 pim rp-address address group-address group-address mask
override
To remove an RP address, use the no ipv6 pim re-address address group-
address mask override command.
Parameters
address
PIM-Sparse Mode (PIM-SM)
Enter the name of the extended ACL that contains the
sources and groups to filter.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced
Enter the IPv6 RP address in the x:x:x:x::x format.
1371