Ip Pim Query-Interval - Dell C9000 Series Reference Manual

ip pim query-interval

Change the frequency of PIM Router-Query messages.
C9000 Series
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
Parameters
seconds
Defaults 30 seconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
Enter a number as the number of seconds between router query
messages. The range is from 0 to 65535. The default is 30
seconds.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-
Series.
PIM-Source Specific Mode (PIM-SSM) 1661