Ip Pim Sparse-Mode - Dell S4810 Reference Manual

priority
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.1
Usage Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
Information

ip pim sparse-mode

Enable PIM sparse mode and IGMP on the interface.
S4810
Syntax
ip pim sparse-mode
To disable PIM sparse mode and IGMP, use the no ip pim sparse-mode
command.
Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
1280
(OPTIONAL) Enter the priority used in Bootstrap election
process. The range is zero (0) to 255. The default is 192.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the E-Series.
Introduced on the S6000.
PIM-Sparse Mode (PIM-SM)